1.Products are manufactured in accordance with all relevant gasket standards.
2.All types of Spiral wound gaskets can be manufactured, CG, CGI, R, RIR, etc.
3.Our production capacity is 150,000 pcs per month.
4.Material combinations for all operating conditions.Â
Â
Sunwell seals spiral wound gaskets have 4 types:
1.SW600-R Basic Type
Basic construction type, inner and outer diameters are reinforced with several piles of metal without filler to give greater stability and better compression characteristics. - Suitable for tongue and groove, male and female or grooved to flat face flange assemblies.
2.SW600-IR Inner Ring Type
Solid inner metal ring acts as a compression stopper. To prevent accumulation of solids, reduce turbulent flow of process fluids and minimize erosion, damages of gasket between flange bore and the inside diameter, the annular space is filled up by solid inner metal ring. - Suitable for male and female pipe flanges.
3.SW600-CGÂ Outer Ring TypeÂ
Solid outer ring accurately locates the gasket on the flange face to give the additional radial strength to prevent the gasket blowout and acts as a compression limiter. In case of installing the outer ring, it is very easy to install the gasket to flange face because the end of outer ring will touch at bolts - Suitable for use with flat face and raised face flanges. For class 900 and above an internal ring is recommended.
Â
4.SW600-CGI Inner & Outer Rings Type
A inner ring and outer ring type gasket will give an additional compression limiting stopper for gasket inner and outer side. It will prevent the corrosions on flange face at annular space. - Suitable for use with flat face and raised face flanges and specified for high pressure / temperature service - Class 900 and above or where corrosive or toxic media are present.
Spiral wound gaskets
More information of spiral wound gaskets,please contact with sunwell seals,thanks.
Blowing agents, be defined as compounds which are thermally unstable and decompose to yield gas at the desired polymer processing temperature, are widely used to expand rubber, plastics to create foam. Most of the chemical blowing agents are organic chemicals, while inorganic chemicals are few.
Ac Blowing Agent is an azodicarbonamide blowing agent for rubber and plastics. It has a relatively high decomposition temperature which can be effectively reduced by the addition of small amounts of activators.
Azodicarbonamide, ADCA, ADA, or azo(bis)formamide, is a chemical compound with the molecular formula C2H4O2N4.[1] It is a yellow to orange-red, odorless, crystalline powder. It is sometimes called a 'yoga mat' chemical because of its widespread use in foamed plastics
It is a foaming agent commonly used in industry, which can be used in the production of yoga mats, rubber soles, etc. to increase the elasticity of products, and also can be used in the food industry to increase the strength and flexibility of dough.
Ac Blowing Agent,Adc Blowing Agent,Adc Blowing Agent Tds
HENAN JINHE INDUSTRY CO.,LTD , https://www.hnchromiumoxidegreen.com