In the actual design of automotive radiators, it is necessary to comprehensively consider the heat transfer performance, resistance performance, economy, and reliability. The model simplifies simplification of louvers with louver fins into multiple cuboid porous media regions. Due to the thin wall and large area of ​​the heat-dissipation tube studied, the wall of the heat-dissipation tube is simplified into a double-sided wall with a corresponding thickness so as to reduce the number of solid meshes, and at the same time reduce the coupling heat transfer between the cold and hot sides of the simulated radiator. Calculate the workload. The simplified heat sink model is more suitable for engineering calculations. The creation of watershed structure and grid division use the mesh of the radiator calculation model. After simplifying the core part of the radiator and the air basin structure, the division method is used to generate the hexahedral structured grid.
The water room part of the radiator is divided using the method. Set boundary conditions: Inlet boundary conditions: according to the control method of the automotive radiator in the heat transfer wind tunnel test on the inlet test conditions, the inlet and outlet inlets adopt the speed inlet, the speed direction is perpendicular to the inlet plane, and the inlet measured according to the test The data is set for speed and temperature. Outlet boundary conditions: Outlet outlets and outlets use pressure outlet boundary conditions. Static pressure and "backflow" conditions need to be defined at the pressure exit boundary. The "reflow" condition is a boundary condition used when reflux occurs at the pressure exit boundary. Wall boundary conditions: Since all radiators in the study are stationary, there is no surface chemical reaction, and radiation is ignored. Therefore, this paper mainly sets the thermodynamic boundary conditions for the walls. Because strict thermal insulation is performed in the heat transfer tunnel test, it is assumed that the outer wall of the air channel and the outer wall of the water are heat insulating walls, that is, the heat flux is set to be. According to the simplification of the radiator model, the wall of the water pipe becomes a double wall surface with corresponding wall thickness. Only by coupling the positive and negative sides in the calculation, the solver can calculate the wall surface directly using the flow field variables of the adjacent grid. Heat exchange.
Injection Molding Parts,Custom Plastic Injection Molding Parts,Medical Instruments Plastic Parts,Plastic Injection Molding Parts
Suzhou Dongye Precision Molding Co.,Ltd. , https://www.sjinjectionmolding.com