Liwan District, Guangzhou City, West Yu An Wai transformation project (two)

Project Name: Reconstruction Project of West Yuanwei, Liwan District, Guangzhou City (Phase II)
Region: Guangdong Progress: Environmental Impact Assessment Construction Period: 2011-2012 Major equipment: firefighting facilities, security facilities, water supply and drainage facilities, cranes, excavators, ventilation facilities, and lighting facilities. (for reference only)
Project Profile: The project is located in the Yuanwei section of Xicun Village, Liwan District, Guangzhou City. The total investment of this project is 500 million yuan, with a total land area of ​​48175 square meters and a total construction area of ​​138,907 square meters. Mainly used for the construction of rehabilitation housing and real estate development and construction. The total investment of the project is 500 million yuan.
Construction Unit: Xilang Stock Cooperative Economic Union, Dongdun Street, Liwan District, Guangzhou Postal address: No. 112, Xilang Jiang Ha Village, Liwan District, Guangzhou, Guangdong Province 5100000, China
Telephone Design Unit: South China Normal University (EIA)
Postal address: Shipai, Tianhe District, Guangzhou Postcode: 510,000 Contact: Miss Zhang Tel Fax
Related Developments: Tower Crane Infrastructure Project

The five most common types of car sensors parts:
1. Throttle position Sensor
The throttle position sensor is mounted on the throttle door to detect the throttle opening. It is connected with the throttle gate through the lever mechanism, and then reflects the different working conditions of the Engine Auto Parts. This sensor can be detected in different operating conditions of the engine input electronic control unit (ECU), so as to control the different fuel injection volume.
2. Inlet pressure sensor
The inlet pressure sensor can measure the absolute pressure in the intake manifold according to the load state of the engine, and convert the electrical signal and the rotational speed signal into the computer as the basis for determining the basic fuel injection quantity of the injector.
3. Crankshaft Position Sensor
Computer-controlled Ignition System is the most important sensor, its role is to detect the top stop signal, crank angle signal and engine speed signal, and input into the computer, so that the computer can be in the ignition sequence of the cylinder issued the best ignition time instructions.
4. Air Flow sensor
Air flow sensor is to convert the inhaled air into electrical signals sent to the electronic control Unit (ECU), as a decision to fuel injection of one of the basic signals.
5. Knock Sensor
The detonation sensor is installed on the cylinder of the engine to monitor the detonation of the engine at any time. At present, there are two kinds of resonant and non resonant type!

The car sensor is the input device of the automobile computer system, it transforms the information of various working conditions, such as the speed, the temperature of the medium, the engine running condition, into the electric signal to the computer, so that the engine is in the best working condition. Car sensors are many, to determine the fault of the sensor, should not only consider the sensor itself, but should consider the entire circuit failure. 

Sensor Auto Parts


Sensor Auto Parts

Sensor Auto Parts,Rear Wheel Speed Sensor,Speed Sensor,Wheel Speed Sensor

Jinan Dingtai Auto Parts Co., Ltd. , http://www.dthavalparts.com

Posted on