There are several ways to install high-voltage pulse electronic fences?

I. Impulse Electronic Fence Auxiliary Installation Auxiliary electronic fence is attached to the upper or inner side of the fence or fence. The fence directly bears the pressure and wire tension of the electronic fence. Therefore, the structural strength of the wall must be ensured before installation. If it is not firm, it should be reinforced beforehand. The distance between the top metal conductor line at the front end of the electronic fence and the top of the wall or the fence shall be less than 700mm.

Second, the pulse electronic fence wall top type installation wall type electronic fence, directly installed on the top of the wall above. The wall height should be above 1.8m. The installation of poles can be welded, clamped or embedded in three ways, depending on the condition of the wall structure and choose a more appropriate way. For example, the welding method may be used on a fence. On concrete walls, pre-embedded methods can be used, and clamps can be used on brick walls. As long as it is stable and beautiful, you can also use other methods.

Third, the pulse electronic fence independent installation will be installed in the electronic fence around the building. Since its height is not less than 1800mm, and the number of wires is 8-20, the tension between the wire and the terminal pull rod and the bearing rod is relatively large. Therefore, the terminal pull rod and the bearing rod must have sufficient strength, and the terminal pull rod must have sufficient strength. The bearing rod must be laid firmly. If the soil is solid, the terminal pull wire and the lower end of the bearing rod can be directly buried in the ground for 60 cm. If the terminal bar is not rigid enough, support should be added. The middle bearing rod, although not subject to the tension of the wire, must support multi-line pressure, and therefore, it needs to be installed securely. Can be buried installation. As shown in Figure 12 line independent installation

Composite Nylon Plastics Material POM

1 What's Polyoxymethylene (POM) ?
Polyoxymethylene (POM), also known as acetal , polyacetal, and polyformaldehyde, is an engineering thermoplastic used in precision parts that require high stiffness, low friction and excellent dimensional stability.

2 Properties

♣POM is characterized by its high strength, hardness and rigidity to -40 °C. POM is intrinsically opaque white, due to its high crystalline composition, but it is available in all colors.

♣POM homopolymer is a semi-crystalline polymer (75-85% crystalline) with a melting point of 175° Celsius

♣POM copolymer has a slightly lower melting point of 162 – 173° Celsius.

3 POM advantages
♥High abrasion resistance
♥Low coefficient of friction
♥High heat resistance
♥Good electrical and dielectric properties
♥Low water absorption

Pom Granules,Pom Plastic Resin,Pom Plastic Material,Pom Plastic Granules

Zhejiang Xinli New Materials Co,.Ltd , https://www.shinylon6.com