Tips for installing initial filters

First, the new pre-filter must be cleaned with a special detergent before use to avoid the use of acids


Cleaner wash.
Second, after cleaning, high-temperature steam is also required for sterilization and disinfection. After cleaning, equipment should be properly placed.
Third, when the installation should pay attention to the direction of the import and export can not be reversed, it is necessary to pay attention to the bottom of the mouth is the entrance, the filter plug


The pipe on the mouth is the exit.
Fourth, put the filter when it is placed vertically, after inserting the plate with the tip of the fins, tighten the screw to keep it


can.
Fifth, when the equipment is used, the pressure is maintained at about 0.1 MPa, and the filter may go out with the increase of the use time and flow rate.


There is a slight blockage.
6. Even if the pressure on the equipment is increased, it must not exceed 0.4 MPa, otherwise the filter element will be damaged.
7. The pressure gauge in the primary air filter is used to indicate the pressure of the liquid. If it is a secondary filter, then


The pressure gauge of the filter will be slightly smaller.
Eighth, the longer the use of a primary filter, the longer the pressure will gradually increase and the flow rate will slow down. This time


It shows that the filter element in this device has been blocked and needs to be replaced in time.

Mono Ammonium Phosphate

Mono ammonium phosphate is an excellent nitrogen & phosphorus fertilizer. When in the soil it is acidic so it widely used in alkaline soil, and it is better not too close to the seeds in order to protect it. when we use it do not mixed together with alkaline fertilizers. When you have to use both, you`d better make them a few days apart. It can provides an equal balance of nitrogen and phosphorus. It also can help the root of crop grow vigorously, improve fruit quality and yield, enhance crop resistance to disasters.

Mono Ammonium Phosphate

Crystal

Granular

Items

Standard

Standard

Appearance

White crystal

White or grey white Granular

N

12%min

11%

P

61%min

44%

Fe

0.0005 %max

0.0005 %max

NO3

0.001 %max

0.001 %max

Moisture

1.0%max

1.5%max

Water insoluble matter

0.1%max

--

Size

--

2-4mm


Mono ammonium Phosphate is suitable for general crops and soils especially alkaline soil, but there`re still some points to note.

1. Cannot be contacted/mixed with alkaline substances.

2. Cannot be applied on the same farmland for a long time.

3. Not too close to the seeds.


Mono Ammonium Phosphate,Crystal Mono Ammonium Phosphate,Monoammonium Phosphate Crystal,Mono Ammonium Phosphate Map

Hebei Woldi Trading Co.,LTD , https://www.woldigroup.com

Posted on